Ordering a reliable hole-marking jig for leather belt production
A maker producing belts in short runs loses time marking the same holes repeatedly. A simple jig can keep the spacing consistent, but an inaccurate template may spoil an entire batch of leather. Before asking a laser-cutting service, woodworker or toolmaker fo
Draw the complete marking operation
Show where the measurement starts, how many holes are needed and which edge or feature the jig registers against. Specify belt widths, rounded tips and any change in dimensions after finishing. Precise holes will still vary if there is no common reference point. Keep a successful sample belt for comparison, while avoiding unnecessary disclosure of confidential production information.
Design a stable and safe contact method
The template should not slide or mark the visible side of the leather. Discuss smooth edges, clamps and a way to clean away dust. If a striking punch will be used, never design a guide requiring a hand to sit in the line of impact. The fabricator can supply a marking guide, but the workshop remains responsible for safe working procedures.
Test one numbered prototype first
Ask for a single version-labelled jig rather than ordering the full quantity. Test it on offcuts of different thicknesses, checking hole spacing and how quickly the belt can be positioned. Errors near an end may indicate a badly chosen reference surface. Record the variation and send the maker photographs with a ruler instead of only saying that the holes are crooked.
Agree on revisions and drawing ownership
State who owns the finished drawing, whether a spare jig may be made and how many rounds of dimensional changes are expected. This matters when several small workshops share a tool design. Keep the final file with its version number, manufacturing method and material details. A familiar filename without version control can lead to an incorrect replacement order.
A hypothetical small-workshop example
Imagine a leather studio in Sheffield making belts in two widths. It draws both specifications, consults a local maker and tries one jig on production offcuts before ordering anything else. This does not claim that a named supplier or order exists. Consistent marking never replaces checking each finished belt or following safe punching practices.
Find a maker through Match2Go
Match2Go is a geosocial service made by people, for people. Describe the jig, measurements and prototype requirement, then speak directly with anyone who responds; availability is not guaranteed. The project does not buy paid advertising and grows through recommendations. If this helps small workshops work together, tell friends and colleagues about Match2Go so more people connect without intermediaries.
Match2Go is currently Russia-focused; local participants outside Russia are not verified.
People agree directly. Matches and replies are not guaranteed. Post a genuine request on Match2Go